Bard W70A1 Manual de usuario descargar pdf (Pagina 8)

Form No. S3409-1112

Supersedes S3409-712

Page 8 of 8

Bard Manufacturing Company, Inc.

Bryan, Ohio 43506

www.bardhvac.com

Due to our continuous product improvement policy,

all specifications subject to change without notice.

Before purchasing this appliance, read important

energy cost and efficiency information available from

your retailer.

sledoM L07W,A07W

noitpircseD

dellatsnIyrotcaF

.oNedoC

dellatsnIdleiF

.oNtraP

dradnatS-repmaDriAhserFcirtemoraB X5-DAFB

etalPffO-knalB B5-POB

repmaDriAhserFdezirotoM M5-DAFM

tsuahxE/wnruteRgnirpS-rotalitneVlaicremmoC V5-SVRC

yplahtnE,snoisreVloohcS-rezimonocE 4 S5E-SMWNOCE 32

yplahtnE,.gdlBtnempiuqE-rezimonocE 5 W5E-TMWNOCE 2

pmeTBD,.gdlBtnempiuqE-rezimonocE 5 T5T-TMWNOCE 2

tloV032-rotalitneVyrevoceRygrenE 3 R5A-FVRE 1

tloV064-rotalitneVyrevoceRygrenE 3 R5C-FVRE 1

)deriuqeR(FVREroftiKrooD A/N-5KDMW 3

Ventilation

Note: For 0KW and circuit breakers (230/208 Volt) or toggle disconnects (460 Volt) applications, insert 0Z in the KW field of the model number.

See Page 2 for available Factory Installed KW options and Field Installed Heater Packages.

seludoMlortnoCgninoitidnoCriA

L07W,A07W

CPH

CPL

MCC

CAL

RLA

TDO

CDD

edoCdellatsnIyrotcaF traPdellatsnIdleiF

DTSDTSDTS XA/N

DTSDTSDTS



E82-AMC

DTSDTSDTS



JylnOyrotcaF

DTSDTSDTS



K82-AMCdna51-CMC

DTSDTSDTS



MylnOyrotcaF

DTSDTSDTS



ylnOL81W,NA/N

DTSDTSDTS



ylnOdellatsnIdleiF51-CMC

DTSDTSDTS



ylnOdellatsnIdleiF41-AMC

DTSDTSDTS

 



ylnOyrotcaF

DTSDTSDTS



ylnOdellatsnIdleiF42-AMC

DTSDTSDTS



ylnOdellatsnIdleiF711KS

STD = Standard equipment for these specified models.

1 HPC. High pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3.

2 LPC. Low pressure control is auto reset. Always used with compressor control module (CCM) which is included. See note 3.

3 CCM. Compressor control module has adjustable 30-second to 5-minute delay-on-break timer. On initial power-up, or any time the power is interrupted, the delay-on-make will be 2-

minutes plus 10% of the delay-on-break setting. There is no delay-on-make during routine operation of the unit. The module also provides the lockout feature (with 1 retry) for

high and/or low-pressure controls, and a 2-minute timed bypass for low-pressure control.

4 LAC. Low ambient control permits cooling operation down to 0°F

5 ALR. The alarm relay has a set of normally open and normally closed dry contacts to provide the ability to signal a condition of shutdown on either high or low pressure controls.

6 SK. PTCR start kit can be used with all -A single phase models. Increases starting torque 2-3x. Not used for -B or -C three phase models. Do not use if SK117 is used.

7 SK. Start capacitor and potential relay start kit can be used with all -A single phase models. Increases starting torque 9x. Not used for -B or -C three phase models. Do not use if

CMC-15 is used.

8 ODT. Outdoor thermostat is adjustable from 0 to 50°F. It is suitable for use as a compressor cut-off thermostat.

9 DDC. Incorporates 4 additional sensors: discharge air temperature, indoor blower airflow, compressor current, and dirty filter. These sensing devices function to input analog data

such as temperature, as well as digital data such as airflow, compressor status or filter status.

 “V” control module should be ordered in conjunction with direct digital controller (DDC) model TCS24. Refer to DDC specification sheet S3280 for more information.

SERIES |

| CONTROL MODULES

(See Chart Below)

REVISION

VOLTS & PHASE |

A - 230/208/60/1

B - 230/208/60/3

C - 460/60/3

COLOR OPTIONS

X - Beige (Standard)

1 - White

- Buckeye Gray

5 - Desert Brown

8 - Dark Bronze

A - Aluminum

S - Stainless Steel

FILTER OPTIONS

X - 1-inch Throwaway (Standard)

W - 1-inch Washable

P - 2-inch Pleated

| COIL OPTIONS

X - Standard

1 - Phenolic Coated Evaporator

2 - Phenolic Coated Condenser

3 - Phenolic Coated Evaporator

and Condenser

| OUTLET OPTIONS

X - Front (Standard)

NOMINAL

CAPACITY |

70 - 6 Ton

W 70 A 1 A 10 X X X X X X

VENTILATION OPTIONS

(See Table Below)

TYPE

A = Compressor & Controls - Right Side

L = Compressor & Controls - Left Side

Air Conditioning Wall-Mount Model Nomenclature

Form No.

S3409

November, 2012

Supersedes S3409-712

1 Intake and exhaust can be independently adjusted.

2 Insert color to match unit ("X" = Beige; "4" = Buckeye Gray; etc.)

3 WMDK Door Kit must be ordered in addition to ERVF Assembly and ECOMWMS & color matched to unit ("X" = Beige; "4" = Buckeye Gray; etc.)

4 Partial Full Flow (75% of Rated Cooling CFM). All ECONWMS versions have 3" deep intake hood.

5 Full Flow (100% of Rated Cooling CFM). ECONWMT-5 has 18" deep intake hood.

1 2 3 4 5 6 7 8

Comentarios a estos manuales

Sin comentarios

Bard W70A1 Manual de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Bard W70A1